How to Remove the Garden Hose from Pressure Washer? The connection of a garden hose to the washer is not tricky, but it may give you a tough time when it comes to removal of the garden hose. And while removing the garden hose, many people in a fury break a sweat. Are you facing the same issue with your corroded garden hose? And your pressure washer is frustrating you? Then you are not alone. Just a few simple steps will lead you to the smooth removal of the hose from a pressure washer. Just sit back and be patient.
Firstly you have to look at the root cause because of which the hose is stuck. It may be excessive tightening or corrosion, after finding the reason, now wear your safety gloves and hold your pliers firmly. With the help of warm water, make the metal contract and then use a wrench at the end of the connector to remove the hose completely without putting forth much effort.
Some reasons which may make your garden hose to stuck in pressure washer
Even if you remain successful in getting one of the best garden hoses for pressure washers, still at some spot, it may show you a tough time due to many underlying causes.
One reason may be the excessive tightening of the hose in a pressure washer. This makes it impossible for the user to remove the connector without using tools.
It may be due to damage, corrosion, or a bent into the connector of the hose.
Unreleased pressure can also be a cause contributing to difficulty to remove the garden hose.
The thing that you will need to start the procedure
You need to gather some of the frequently available tools for proceeding towards the main procedure. The main tools include
- Pliers
- Lubricants
- Hacksaw
- Pipe wrench
- Rubber gloves and hot water
Step 1: Wear your rubber gloves
Yes, you want to get the accurate and desired results without bothering your safety. In that case, it is necessary to wear rubber gloves to stay safe from any debris or injuries during the removal process.
Step 2: Take your pliers out
Now take your firm pliers and hold the end of the connectors of the hose. Start moving the pliers in the anticlockwise direction. But make sure that you are holding the connector in place.
Step 3: Now comes the wrenches
Wrenches are the best thing to have when your tight pipe fittings are creating a mess for you. You have to hold each end of the connector firmly with a wrench. Put as much pressure as the fitting demands. Hopefully, after this step, your hose is ready to get removed.
Step 4: Pour some hot boiling water on the connector
Your next step to proceed further is to get some hot boiling water and pour it carefully at the hose connectors. This contracts the metal, which makes a gate for the easy removal of the hose from a pressure washer.
Twist the connectors carefully while wearing safety gloves and relax the connectors before the metal cools down.
Steps 5: Add some lime solution into the connector
If you want to keep your metal hose working finely for a more extended period, then you should go for a lime wash. This will help you to clean the corroded parts or any debris accumulated in the washer or hose.
If you don’t clean the hose effectively, this may cause blockage to water flow in the near future.
Step 6: Use a good quality lubricant
Now you have to pour some good quality lubricant in the hose creases. Allow the lubricant to sit for a while before winding up. This will keep the hose safe from corrosion and getting stuck again.
But keep one thing in mind, if the hose is not in the condition to get reinstalled, you need to get a new one that may be effective enough to replace the older one.
Final verdict
For every homeowner, a pressure washer is an important part of daily chores. And when it gets stuck with the garden hose, this grounds colossal inconvenience. In order to overcome this issue, you just have to follow a few easy steps on how to remove the garden hose from the pressure washer after gathering some frequently available tools. And without causing any further damage, you will get your problem solved.