When you want to use a brad nailer, the first thing you must look for is the nailer to be light in weight and easy to use. You don’t have to look anymore as both of these features are available in brad nailers designed by Porter-Cable. However, these two features are not the only thing you need to know about these nail guns. If you are looking for a helpful guide on how to use a Porter Cable brad nailer, you are precisely at the right place.
More about Porter Cable Brad Nailer:
Coming with a removable and non-marring nose tip, this brad tip also has a feature of on-tool storage. Additionally, it comes with an integrated rubber grip to provide you with improved comfort while holding it for more extended periods. Here are some of the fantastic and most prominent features of Porter-Cable brad nailers:[acf field=”how_to”]
- For better visibility, there is contact safety that is located behind the driver guide.
- It comes with an adjustable belt hook that allows the user to keep the tool near.
- Includes an indicator for indicating low nail reload.
- There is a rear exhaust that helps keep contaminates away while you work.
- A maintenance-free motor that allows keeping the workstation stain-free and clean.
- Able to drive 18 gauge nailers ranging from the length of 5/8 of an inch to 2 inches.
- For easy nail removal, it includes a tool-free jam release.
- It comes in a kit that includes the owner’s manual and carrying case.
How to use a Porter Cable Brad Nailer:
Now that you finally know the main and unique features that brad nailer by Porter cable have to offer, here is a simple and easy guide to let you know how to use a Porter cable brad nailer:
Step 1:
Take the end of the hose and push it in the coupling while moving the coupling sleeve back. Push the hose until you hear the lock sound.
Step 2:
You have to load up the nail gun to not get disturbed by the reduction of nails. All you have to do is turn around the brad nailer and press the button that is located below the nail gun tip. When the slide latch located at the rear end of the nailer slides out, put the nails and then move back the slide latch to its original position until it locks.
Step 3:
Now connect the nailer with the compressor using the air hose, and you are ready to use the brad nailer.
Step 4:
Turn on the compressor which will make a lot of noise, and let it go on for one or two minutes. Once you have given some time, now you are good to go.
Step 5:
Set the pressure on the air compressor according to what you require. For the demonstration, put the wooden nailer on the wooden piece you want to work on and press the trigger to check if the nails hold the wooden piece together. If yes, you are ready to get your job done!
